Table Switch Board Replacement
This document outlines the replacement of the CO2 laser tube in the Fusion Maker, Edge, and Pro 24 and 36. After replacing the CO2 laser tube, complete the laser alignment and focus calibration procedures.
Front Door Interlock Replacement – Fusion Pro 32 & 48
Please find the attachment for an in-depth description.
Updating the IRIS Camera System
This document outlines the IRIS camera system update procedure in the Fusion Maker, Fusion Edge, and Fusion Pro.
Autofocus Repair Guide: Replacing the Autofocus Plunger (AFP)
Estimated time: 15–20 minutes • Skill: Beginner This procedure will guide you through the process of removing and replacing the Autofocus Plunger (AFP) assembly on your laser system. The AFP is a critical component used to automatically set the correct focus distance between the laser head and the material surface. (...)
JPT 50 Watt Fiber Laser Conversion – Fusion Pro 48
This document outlines the installation of the JPT 50-watt fiber laser conversion kit in the Fusion Pro 48.
Air Assist Tubing Replacement – Fusion Maker, Edge, Pro 24 & 36
The Air Assist (AA) Tubing in your engraver plays a crucial role in ensuring optimal performance by directing a stream of air to the engraving area. Over time, this tubing may wear out or become damaged, necessitating a replacement. This guide provides a step-by-step process for safely removing and installing (...)
X-Axis Reducer Belt Replacement – Fusion Edge, Pro 24 & 36
The X-Axis Reducer Belt is a crucial component in ensuring the smooth and precise movement of the engraving machine. Over time, it may require replacement due to wear and tear, ensuring that the engraver continues to perform at optimal efficiency. This guide provides step-by-step instructions for safely removing and installing (...)
Carriage Camera Replacement – Fusion Pro 24 & 36
This document outlines the replacement of the carriage camera assembly in the Fusion Pro 24 and 36.
Table Motor Replacement – Fusion Pro 32 & 48
This document outlines the replacement of the z-axis motor in the Fusion Pro 32 and 48.
X-Axis Assembly Replacement – Fusion Maker, Edge, Pro 24 & 36
This document outlines the replacement of the x-axis assembly in the Fusion Maker, Edge, and Pro 24 and 36.
Table Motor Replacement – Fusion Maker, Edge, Pro 24 & 36
This document outlines the replacement of the z-axis motor in the Fusion Maker, Edge, and Pro 24 and 36.
Top Door Gas Shock Replacement
This document outlines the replacement of the gas shock on the top door of the Fusion Pro 32 and 48.