X-Axis Motor Replacement
This document outlines the replacement of the x-axis motor in the Fusion Pro 32 and 48.
Y-Axis Home Switch Replacement
This document outlines the replacement of the y-axis home switch in the Fusion Maker, Edge, and Pro 24 and 36.
X-Axis Air Assist (AA) Tubing Replacement – Fusion Pro 32 & 48
The X-Axis Air Assist (AA) Tubing Replacement process for the Fusion Pro 32 and 48 engravers ensures proper air flow during operation. Over time, the tubing may wear out and require replacement to maintain optimal performance. This guide provides step-by-step instructions on how to safely remove and install new AA (...)
SD Card and Coin Battery Replacement – Fusion Pro 32 & 48
This guide provides instructions for replacing the SD card and coin battery in the control module of Fusion Pro 32 and 48 systems. Always follow proper anti-static precautions and use the correct tools and parts. Control Module Removal Turn off the engraver. Disconnect the engraver from the power source. Disconnect (...)
X-Axis Belt Replacement – Fusion Edge and Pro
This document outlines the replacement of the x-axis belt in the Fusion Edge, and Pro.
Fixing Table Movement: Replacing the Z-Axis Belt
Estimated time: 30–45 minutes • Skill: Intermediate This procedure guides you through removing and installing the Table (Z-Axis) Belt on Fusion Pro 32 & 48 laser systems. Follow these steps to ensure correct belt routing, proper tension, and smooth Z-Axis motion for precise engraving. Z-Axis Belt Removal Power down and (...)
Floating Backplane Upgrade
Applies to: Fusion Pro 32 • Fusion Pro 48 This guide provides step-by-step instructions for upgrading the floating backplane board in Fusion Pro 32 and 48 engravers. Designed for models manufactured before mid-2020, this procedure ensures proper installation and configuration of the new backplane board. By following these instructions, you (...)
Top Door Gas Shock Replacement – Fusion Maker, Edge, Pro 24 & 36
This document outlines the replacement of the top door gas shock in the Fusion Maker, Edge, and Pro 24 and 36.
X-Axis Assembly Replacement – Fusion Pro 32 & 48
This document outlines the replacement of the x-axis assembly in the Fusion Pro 32 and 48.
Power Supply Replacement – Fusion Maker, Edge, Pro 24 & 36
This document outlines the replacement of the power supply in the Fusion Maker, Edge, and Pro 24 and 36.
Backplane Board Replacement – Fusion Pro 32 & 48
This document outlines the replacement of the backplane board in the Fusion Pro 32 and 48.
Y-Axis Bearing Block Assembly Replacement
This document outlines the replacement of the y-axis bearing block assembly in the Fusion Maker, Edge, and Pro 24 and 36.