Focus Calibration Wizard
Focus Calibration Wizard Click the Gear icon in the upper-right corner. Select Focus. Select the lens aperture. Note: If you...
Front Door Interlock Replacement – Fusion Pro 32 & 48
Please find the attachment for an in-depth description....
Fusion Maker, Edge, Pro 24 & 36 – Linear Guide (Rev 1 IKO) Replacement
This document provides concise, step‑by‑step instructions for removing and installing the X‑Axis linear guide (IKO rail) on Fusion Edge, Maker,...
Generating Machine Logs
Generating machine logs enables Epilog Technical Support to gather important information about the machine, aiding in its diagnosis and troubleshooting....
How to Install the Strain Relief Kit
Estimated time: 10–15 minutes • Skill: Basic This guide explains how to install the strain relief kit on the lens...
How to Replace the CO₂ Laser Tube & RF Unit
Estimated time: 60–90 minutes • Skill: Intermediate This guide outlines the procedure for replacing CO₂ and 120-Watt laser tubes, as...
How to Replace the Overhead Camera Cables
How to Replace the X-Axis Motor Driver: Step-by-Step Guide
This guide will walk you through the process of removing, installing, and programming the X-Axis Drive Board for Fusion Edge...
IRIS Camera Calibration
This document outlines the IRIS camera calibration procedure for the Fusion Pro 32 and 48....
JPT 50 Watt Fiber Laser Conversion – Fusion Pro 48
This document outlines the installation of the JPT 50-watt fiber laser conversion kit in the Fusion Pro 48....
Large Aperture Optics Replacement – Fusion Pro
The Fusion Pro laser system includes four (4) mirrors in total. Mirrors 1, 2, and 3 are mounted using mirror...
Laser Alignment (Large Aperture Optics) – Fusion Pro
To ensure your CO2 laser engraver delivers optimal performance and consistent cutting quality, proper beam alignment is essential. Over time,...
Laser Alignment – Maker / Edge / Pro
Turn On To begin the laser alignment procedure, power on the laser. For the following procedures, the table will be...
LC1000 – Control Module Port and LED Overview
The control module on Epilog laser systems provides connection points and LED indicators that offer system status and control feedback....
Lens Camera Board and USB-C Cable Replacement – Fusion Pro 32 & 48
This procedure outlines how to replace both the Carriage Camera PCB and the X-Axis USB-C cable on a 16000 Series...
Leveling the Table
This document outlines the table leveling procedure for the Fusion Maker, Edge, and Pro 24 and 36. Table level should...
Leveling the Table
This document outlines the table leveling procedure for the Fusion Pro 32 and 48. Table level should be checked periodically...
Linear Guide (IKO) Replacement – Fusion Pro 32 & 48
This document outlines the replacement of the linear guide in the Fusion Pro 32 and 48....