SD Card and Coin Battery Replacement – Fusion Pro 32 & 48
This guide provides instructions for replacing the SD card and coin battery in the control module of Fusion Pro 32...
Squaring the Y-Axis Actuators
This document outlines the y-axis actuator squaring procedure for the Fusion Pro 32 and 48....
Table Belt Replacement
This document outlines the replacement of the z-axis belt in the Fusion Maker, Edge, and Pro 24 and 36....
Table Lead Screw Replacement
This document outlines the replacement of the lead screw in the Fusion Maker, Edge, and Pro 24 and 36....
Table Motor Replacement – Fusion Maker, Edge, Pro 24 & 36
This document outlines the replacement of the z-axis motor in the Fusion Maker, Edge, and Pro 24 and 36....
Table Motor Replacement – Fusion Pro 32 & 48
This document outlines the replacement of the z-axis motor in the Fusion Pro 32 and 48....
Table Switch Board Replacement
This document outlines the replacement of the CO2 laser tube in the Fusion Maker, Edge, and Pro 24 and 36....
Table Switch Board Replacement – Fusion Pro 32 & 48
This document outlines the replacement of the z-axis board in the Fusion Pro 32 and 48....
Top Door Gas Shock Replacement
This document outlines the replacement of the gas shock on the top door of the Fusion Pro 32 and 48....
Top Door Gas Shock Replacement – Fusion Maker, Edge, Pro 24 & 36
This document outlines the replacement of the top door gas shock in the Fusion Maker, Edge, and Pro 24 and...
Top Door Replacement
Please find the attachment for an in-depth description....
Touchpad Calibration – Fusion Maker, Edge, and Pro 24 and 36
Please find the attachment for an in-depth description.
Updating the IRIS Camera System
This document outlines the IRIS camera system update procedure in the Fusion Maker, Fusion Edge, and Fusion Pro....
Vision System Repair: Replacing the Overhead Camera
Estimated time: 30–45 minutes • Skill: Intermediate This guide outlines the procedure for replacing the overhead camera on the Epilog...
Vision System Repair: Replacing the Overhead Camera
Estimated time: 20–30 minutes • Skill: Intermediate This procedure guides you through removing and replacing the Overhead Camera on Fusion...
When to Calibrate the IRIS Camera System
Applies to: Fusion Maker • Fusion Edge • Fusion Pro • G100 All Fusion Maker, Edge, Pro, and G100 engravers...
X-Axis Air Assist (AA) Tubing Replacement – Fusion Pro 32 & 48
The X-Axis Air Assist (AA) Tubing Replacement process for the Fusion Pro 32 and 48 engravers ensures proper air flow...
X-Axis Assembly Replacement
X-Axis Assembly Removal First, power off and unplug the machine. Using a 5/32” Allen Key, remove the right side panel...